Shop roofs
Crane bays, overhead doors and exhaust from welding and paint booths.
Service area: Nisku and Leduc
Shops, yards and warehouses in one of Western Canada's largest industrial parks.
Local roofing
Commercial roofing in Nisku means shops. Nisku Business Park is one of Western Canada's largest industrial parks, about 5,050 acres with more than 400 businesses, many of them serving the energy sector. The typical building is a steel or block shop with large overhead doors, crane bays and an office at the front, sitting on a wide, flat lot near Edmonton International Airport.
Leduc adds retail, offices and institutional buildings to the mix. Rain Roofing works across both, from shop re-roofs in the park to flat roofing repairs on Leduc plazas.
Crane bays, overhead doors and exhaust from welding and paint booths.
ISNetworld, Avetta and ComplyWorks for energy-sector clients.
24/7 emergency response with crews on site within 4 hours.
A Nisku shop roof works harder than it looks. Welding and paint booth exhaust lands on the membrane. Overhead crane rails and heaters hang from the structure, so a leak lands right where people work. And many shops have been expanded more than once, which leaves joints between old and new roof sections that move differently through the seasons.

Much of the land around Nisku and the airport is open and flat, so wind has a long run at the buildings. Roof edges, corners and loose ballast take the brunt. When we replace a roof here, perimeter and corner securement get as much attention as the field, and we check edge metal and fastening on every inspection. Mechanically fastened and fully adhered systems are usually the better fit than loose-laid ones on exposed sites.
In Leduc itself, the work is more varied: retail plazas, offices, schools and community buildings, alongside light industrial on the edges of the city. The issues are the familiar ones for the region: ponding at drains, freeze-thaw at flashings, rooftop units added without proper curbs, and hail damage after summer storms. Repairs, maintenance programs and replacements on ageing SBS and built-up roofs make up most of the calls. Retail and office work is scheduled around tenants and opening hours, with entrances kept clear and each section closed in at the end of the day.
Many Nisku businesses work for owners who prequalify every contractor, and they expect the same from theirs. Rain is registered with ISNetworld, Avetta and ComplyWorks, holds COR, and provides WCB-Alberta clearance letters and insurance certificates on request. Torch-on work is covered by a hot-work endorsement and done with a fire watch on every job.
Nisku and Leduc are a short run down Highway 2 from Edmonton. Our 24/7 emergency line covers both, with crews on site within 4 hours for active leaks. For shop owners with several buildings, a spring and fall maintenance program keeps every roof on one schedule.
Questions
Usually, yes. Leaks at tie-ins come from two roof sections moving differently. A proper expansion joint or a reworked tie-in detail tends to solve it for good.
Yes. We plan zones around your shop floor and protect equipment and work areas below. Noisy or disruptive work can be scheduled around your busiest shifts.
Yes. Some sites near the airport have extra rules about cranes and access, and we check those during planning.
Rain is registered with ISNetworld, Avetta and ComplyWorks and holds COR. We can send the documents your client needs before work starts.
Send us drawings, a spec or just an address. You get a clear scope, a written warranty and a roofer who answers the phone in a storm.